Car painting booth: AKFS Electro series – an environmental solution for energy consumption by auto repair workshops. International standards. The air is heated by: an electric heat exchanger. High rates of efficiency. Mounted on a flat floor or foundation, with air ducts.
TO CAR WORKSHOPS
For primers, paints, enamel and varnishes
The perimeter of the working area is illuminated by energy-saving powerful LED lamps. The temperature is regulated from the control panel (within 16-24 ° C during the painting process and 20-80 ° C during the drying process). Powerful exhaust system, provides a constant stream of clean, warm air. The spray booth is equipped with an entrance gate and a door for staff.
Conform to international safety standards
- Equipped with automatic fire extinguishing system;
- Made of non-combustible materials;
- Eradication of fans and main elements of the ventilation system;
- Automatic safety locking system – eliminates the possibility of supply of paint or compressed air to the spray devices, in the event of termination of ventilation.
Car painting booth
Basic equipment
- Electric heat exchanger;
- Set of wall panels 50mm thick;
- Service doors for staff;
- Entrance gate;
- Centrifugal ventilation unit, supply, with electric motor;
- Centrifugal exhaust ventilation unit, with electric motor;
- Gate device with pneumatic drive;
- Damper for manual adjustment of air pressure in the chamber cabin;
- A set of pre-filters, discharge filters and feed;
- Set of frames for emission filters;
- Pressure measuring instrument in a chamber cabin;
- Ceiling construct with a set of ceiling filter frames;
- Set of floor gratings, max load – 800 kg / wheel (if installed on the foundation);
- Control panel with automation systems;
- Temperature controller;
- Hour meter;
- Timer to control the drying time;
- Set of LED ceiling lights 4x18W.
Technical specifications
For basic configuration*
Models |
AKFS-E-7-26 |
AKFS-E-9-31 |
---|---|---|
Dimensions* |
||
The internal size of the working area (LxWxH) | 7х4х2,7 m | 8,6х4,5х3 m |
Entrance rolling gates (WxH) | 3х2,6 m | 3х2,9 m |
Doors for staff (WxH) | 0,7х1,9 m | |
Power ventilation systems |
||
Exhaust ventilation unit | 7,5 kW | 11 kW |
Sailing ventilation unit | 15 kW | 18,5 kW |
Air productivity | 26000 m³/h | 31000 m³/h |
Air refresh rate | ≥340 set/h | ≥260 set/h |
Air speed | 0,25 m/sec | |
Lighting |
||
Energy saving lights LED Т8, 1200х4×18 | 8 pcs | 10 pcs |
Air temperature in the working area |
||
Painting mode | 16-24 °С | |
Drying mode | 20-80 °С | |
Walls |
||
Fireproof Sandwich Panel Thickness | 50 mm | |
Floor grating*** |
||
2 rows, maximum load (special foundation) | 800 kg/one wheel | |
Electricity |
||
Power supply | 3 phases/380V/ 50 Hz | |
Total electricity consumption | 23,1 kW/h | 30,2 kW/h |
*- Characteristics designed for execution as standard. Camera performance increases significantly when using optional accessory nodes. **- The external dimensions of the chamber depend on the type and location of the ventilation unit. ***- subject to the choice of installation type on a special foundation.